Start with headphones place on your left hand hand like so, with the earbuds laying in your palm and the cords wrapped behind and around your thumb, swept the right.
Place the loose cord between your pinky and ring finger as shown. Pinch the cord between your thumb and your palm to keep it securely in place.
Wrap cord towards you across your palm, and tuck it back behind your thumb like you did in step one, With the loose end of the cord laying across your palm.
Repeat step two and three over and over again until you're left with about 2 inches of cord.
Keeping the wrapped cord carefully in position, slip it off of your fingers and pinch it in the middle like so.
Using the loose end of the cord (the end that plugs in, not the earbud end), wrap very tightly around the middle several times, until you have about an inch left.
Using the metal plug, stick it firmly down in the middle of the wrap.
Push the plug through so that you can see the plug come out the other end. Push as far as you can and as tight as possible.
Voilà! Tight securely wrapped headphones that will not budge.
- Earbud headphones