STEPS
TOOLS
WARNING I recommend you having a parent/guardian helping you start the car.
Make sure you have the premixed nitro fuel in your fuel tank locates in the middle of the car.
Make sure you have put batteries in the car(itself) and the remote(itself).
Located here.
And also here
Step 1,if not already leave the 7.2 volt battery on charge for at least 4 hours for the full performance.
Step 2 take the battery of the charger and put it in its case,make sure its all clipped in so the battery does not fall out.
You should end up like this.
After you have clipped the battery in it case put the front of the battery.
Which should look like this.
Turn on the remote (should be located on the right far bottom side)and the car(located in its rear).
The cars switch should located above the 4 pins to place your batteries
And the controller.
You should end up like this.
Press and hold down the bright red button that should end up your car sounding like this
When starting up you car make sure to rev the controller a little bit but not too much to make your car flood.
If the did not start you should replace you glow plug(located inside the engine) or try replacing the batteries in your controller and car,if none of the above help please go to your local hobby shop
If this didn’t start your car please take the car to your local hobby shop and explain what has been happening to the vehicle,they will check the vehicle and will explain what has been happening
Thanks for viewing my Snapguide,i hope it helped.
- The car itself (suppied in the box)
- Yourself
- The 7.2 volt battery pack(supplied in the box)
- Premixed Nitro fuel
- 12 batteries
- 7.2 volt batterypack carrier case
- The 7.2 battery (charger supplied in the box)
- Clips(supplied in the box)
- Romote(supplied in the box)
- Tools if (nessacary)
The Conversation (0)
Sign Up