Snapguide
STEPS
TOOLS

Save all the broken pieces of your glasses

Pieces

Pieces

Be careful not to tear the ribbon cable inside the glasses

Be careful not to tear the ribbon cable inside the glasses

Fit broken pieces together

Fit broken pieces together

Use a hot soldering iron to slightly melt the plastic pieces together

Use a hot soldering iron to slightly melt the plastic pieces together

Be careful! This is only to hold temporarily.

Be careful! This is only to hold temporarily.

JB Weld is a strong, two-part epoxy!

JB Weld is a strong, two-part epoxy!

Mix in equal parts.

Mix in equal parts.

Mix with a disposable stick

Mix with a disposable stick

Mix completely.

Mix completely.

Gently spread the epoxy over the broken area and beyond for strength!

Gently spread the epoxy over the broken area and beyond for strength!

Cover the entire area and let the epoxy cure for at least 24 hours! Do not move while drying - it may break apart again and it would be a mess!

Cover the entire area and let the epoxy cure for at least 24 hours! Do not move while drying - it may break apart again and it would be a mess!

After the epoxy is dry, you can sand any rough spots and color to match the glasses to make it less noticeable . See you at the movies !

  • JB weld epoxy
  • Soldering iron
  • Mixing stick