STEPS
TOOLS
This is the fabrics I use white for the base and pink
With a ruler I make sure how much fabric need
Then mark the ruler with marker that go of after
And I rolled the white fabric around the can
Her is how much I need
Mark it see that black dot👆
Cut it a little bit
Like that
To make sore that it is perfect
Then with the place you marked at the ruler you can know how much to cut but make sore that you cut more one and half inches
Look like that
And cut it to the dot ( tap to see full pic)
And make a little line ( tap to see full pic )
And put it inside to make sore it's perfect 👌
Put the fabric on the desk
And put the white fabric on top
Cut it and That is what you have
I use white base cos wen i put it on the can its little dark
But with white it is amazing
Put on fabric glue on the white and your ether color and stick them together
Till that dry draw a design to know how to put your ribbons her is my design
Get your glue gun ready
Glue to the can
And the inside
TIP: wen you glue it to the inside glue the hot glue in the fabric then press it to the can but wen you glue it to the can glue it on the can not on the fabric
See that line we have to cover it with Ribbon
For straight lines up on clips
For that way Lin put on bobby pin
If you wanna copy my design put the final ribbon under the first one and go
Here is what mine look like this is horrible but I know but it is just to know that you like your design
Remember the mark we made at the ruler
Add half inch in the beginning and ending
For this way we are doing like what we did to the fabric my English is not good and I want any one to tell me what named this way line
This time do not mark it cut the small cut wen the Ribbon is on the can then cut it all
Here is my ribbons ready to bee glued
First glue the top
I'm gonna cover that with the ribbon
Here is the end sorry I didn't take the other steps cause my glue gun was having a little bit on it and it was coming out it self
I don't have stickers so I'm gonna write on tape
I made Line
I just write on it
Just cut them I put it on the ribbon but doesn't like it so
I made this little bow
I just put it on
And this one too
Get the left overs
Cut them
Glue it on the bottom of the can
If yours doesn't smell bad just skip the next 4 steps
Get body spray
And spray the holder spray to inside too
Make sure that you are not spray it from near or it will be like that
If you did just rub it and you will be fine
Clean that messy
Finally cleaned up
Now better with the pencil holder
Sorry for my bad English and bad spelling and hope you enjoy
- Can
- 1.0 Peace fabric
- Ribbon
- Letter stickers
- Peace of white fabric
- Scissors
- Hot glue gun
- Body spray
- Fabric glue
- Ruler
- Marker
- Paper
- Colored pencil
- Bobby pins
- Clips
The Conversation (0)
Sign Up