How to make cutting boreds

Put the glue in the tube thing. so we know how much to use for the next time. We make a cutting bored.

You have to lay the dowels out with the wood that your using. In the spot that you want them in.

You start applying the glue to the wood only on one side but you can use both sides if you want.

After applying the glue you take your finger and wipe the glue on the side the=at u applied the glue on to make it flat.

You label the wood from A to H so you know where to place the wood together. in the right order.

Then u apply the clamps for 30 minutes. by mistake I ended up putting the big clamp on one of the sides exited of in the middle what you so post to do.

sand the board to make it flat. so you don't have a bad service.

apply the oil three times for 10 minutes but wipe the cutting bored after 10 minutes.

after you all done you bored will look like this all finished.