Snapguide

How to make an up-cycled bird feeder

Make an Up-Cycled Bird Feeder

10
STEPS
TOOLS
Plastic spoon x3.  (If the bird stands on these, the food drops)

Plastic spoon x3. (If the bird stands on these, the food drops)

*Use a small knife, to create 3 holes approximately a quarter from the bottom of the bottle.    *Place the plastic spoons through each holes (make sure the spoons stretch from one side to the other)

*Use a small knife, to create 3 holes approximately a quarter from the bottom of the bottle. *Place the plastic spoons through each holes (make sure the spoons stretch from one side to the other)

Remove the marketing label, and then glue 3mm green rope from the top to about a quarter way  down.

Remove the marketing label, and then glue 3mm green rope from the top to about a quarter way down.

Glue 5mm rope adjacent to 3mm rope to approximately the halfway point

Glue 5mm rope adjacent to 3mm rope to approximately the halfway point

For aesthetic appeal, you can add some 15mm leather at the bottom and below the rope

For aesthetic appeal, you can add some 15mm leather at the bottom and below the rope

Drill a 1mm hole in the bottle cap, and screw a plastic hook inside.

Drill a 1mm hole in the bottle cap, and screw a plastic hook inside.

Finally, use a small knife and create 2 small holes on one side of each spoon. Place 7mm bamboo in each of the holes which act as a platform for the bird to consume the seeds

Finally, use a small knife and create 2 small holes on one side of each spoon. Place 7mm bamboo in each of the holes which act as a platform for the bird to consume the seeds

This should be your finished product.  Enjoy your bird feeder\ud83d\ude00\ud83d\udc26

This should be your finished product. Enjoy your bird feeder😀🐦

  • Medium sized bottle
  • Plastic spoon x3
  • Plastic hook
  • Bird seed
  • 3mm thick green rope
  • 5mm thick rope
  • Glue
  • Small knife
  • 7mm thick bamboo x2
  • Drill