How to make an origami waterbomb

Make an Origami Waterbomb

10
STEPS
TOOLS

For this project, you need to have a Waterbomb base. I have a guide on it on my profile if you don't already know how to make one ;) enjoy!

First, take your Waterbomb base and arrange as shown

First, take your Waterbomb base and arrange as shown

Fold the top most layer corner up to meet the top point

Fold the top most layer corner up to meet the top point

Repeat with each corner

Repeat with each corner

Fold the two top most layers into the middle, like so

Fold the two top most layers into the middle, like so

Repeat on the back

Repeat on the back

Now take the top most layers AGAIN and fold them down aligning the diagonal edge with the vertical edge like so. Repeat this on the back as well

Now take the top most layers AGAIN and fold them down aligning the diagonal edge with the vertical edge like so. Repeat this on the back as well

Now take this flap you folded earlier, I find that if you rotate the paper 90 degrees it helps

Now take this flap you folded earlier, I find that if you rotate the paper 90 degrees it helps

Open up that flap

Open up that flap

And put the flap inside, as shown

And put the flap inside, as shown

One done! Three more to go...

One done! Three more to go...

Step 12 complete

Step 12 complete

Now fold the top and bottom corners into the middle and repeat on the other side

Now fold the top and bottom corners into the middle and repeat on the other side

Finished Waterbomb! I hope you enjoyed! Don't forget to comment, like an follow ;)

If you wanna put water in, there is a hole that allows you to fill it up! Also if its not going 3D then you can blow into this hole!

If you wanna put water in, there is a hole that allows you to fill it up! Also if its not going 3D then you can blow into this hole!

  • 1.0 Waterbomb Base