Snapguide

How to make an inverse fishtail loom bracelet

Make an Inverse Fishtail Loom Bracelet

3
STEPS
TOOLS
Get your bands, clips (I use the 'c' clips), and hook.

Get your bands, clips (I use the 'c' clips), and hook.

Place the first band on like a figure 8.

Place the first band on like a figure 8.

Then add 2 more bands on top of the first one.

Then add 2 more bands on top of the first one.

Now, pull out the middle band...

Now, pull out the middle band...

put it under the bottom one, and pull it out...

put it under the bottom one, and pull it out...

And over.

And over.

Repeat on the other side.

Repeat on the other side.

Now add another band.

Now add another band.

Pull it out...

Pull it out...

over and under...

over and under...

and over the top.

and over the top.

Repeat these steps until it's long enough.

Repeat these steps until it's long enough.

To finish it off, you're going too pull out the top band, put it under the bottom band, and lift the bottom band over the top (like the other steps only with 2 bands).

To finish it off, you're going too pull out the top band, put it under the bottom band, and lift the bottom band over the top (like the other steps only with 2 bands).

Then repeat on the other side.

Then repeat on the other side.

And there you go! Finished! This is what it looks like when you're done

Hope this helped! Put any requests in the comments and I'll see what I can do! Thanks! 😉

The creator of this guide has not included tools