Gather all your supplies
Pick a spot on your wall where you want to hang your display
Mark a line where your studs are
Measure your trim. I measured mine to about 4 and a half feet
Make a "V" mark where the 4 and a half-foot measurement is.
Line your saw with the mark and cut through
...my 4 and a half foot trim...
Scatter the door nobs randomly around the trim and trace around them using your pencil
In every circle you will drill a hole all the way through the trim. Try to get it centred!
Get your painting clothes on!!!!
Start to paint. You can choose any colour
Once your paint has dried, put the screws in from the back
You may need to hammer them in
You want a little bit of your screw sticking up for the nob to go on
Now it is time to twist the nob on
Once your board is done you will then drill a whole through the trim where your studs are
Make sure it's level
Right in the center!!
Drill the screws through the board, into the studs
I put white caps over my screws, but that is up to you
Tie different knots on each nob
Clip the Instax film on
Now, cut the strings at different lengths
It will look like this once your done
For a bonus feature, add a word(s) above it
...your final product!...
- Letters (SMILE)
- Stud finder
- Instax mini
- Instax mini film
- 10.0 Door nobs
- Paint (white)
- White screw caps (optinal)
- Drill bits
- Screw bits
- Safety goggles
- Painting clothes
- Mitre saw
- Small clothes-pins