How to make an infinity rainbow loom bracelet

Start off by making the base of the bracelet

Add one colour band from the first middle to the first left pin.

Add a band from the first left pin to the second left.

Do this all the way up to the second to last left pin.

From there add a band to the last middle pin.

Back at the bottom, put a band from the first middle to the first right pin.

Just like the other side, add a band from the first right pin to the second right.

Do this all the way up except for the second to last pin, then close the gap.

Now to make the "infinities"

Take two bands (they don't have to be different colours)

Put them on the second right pin and stretch it to the left one, but twist it once.

Do this to the next pin(s) up.

Do this all the way up.

Add a cap band on the top middle pin.

Now to loop the bands

Turn around your loom.

Go inside the cap band and grap the top band.

Stretch it to the first left pin. **THIS IS JUST LIKE A SINGLE**

Go inside the cap band again, and stretch the last band over to the right pin.

On the second left pin, take the only band on it and stretch it up a pin.

Again, go inside the pin and grab the loose band, stretching it over to the next pin up.

Do this all the way up.

Then do the same thing, just to the top middle pin.

Just like the other side, grab the band that is loose and put it on the next one.

Close it off.

Put your hook in all of the bands on the top pin, then get a band and put it on your hook.

While holding one side of the band, take your hook and basically take it out of the bands, taking the single band with it. It will make the single band wrapped around the others so they won't fall off

Put the two sides on your hook, and take the bracelet off your loom.

Now for the extension

I like to make the extension for this bracelet with double bands like the infinities, but you don't have to do that.

Put the two colours (or a single band) on the first left pin to the second left.

Do this all the way up, again this is just a single.

Take the two sides off your hook, sliding them onto the top pin.

Go inside the two sides of the band you just placed and take the bottom band(s) and pull them over to the next pin.

Do this until you get to the end.

This is what it will look like. Take a c/s clip and put it on the loose band(s) at the bottom and clip it too the other side of the bracelet.

This is what it will look like, then you're done! Thanks for using my tutorial!!