You will need for step 1 is 6 or 7 coloured or non coloured vinears a wide cramp and titebond3 glue.
Then spread the glue with your figr or a Popsicle stick make sure You glue both sides of the veneers .
make sure you even out your veneers then cramp tem until the ooze the glue.
Then leve the glue to dry over nite.
After a day opin the clap and make sure the glue is dry.
drill as many holes as possible and cut around the them. Sorry I don't have pictures of this step.
Secure your ring in your jig.
Clamp your jig to a tabre.
Saw all of the cornors off your ring.
Un cramp your jig and take your ring
Put your ring on your home made drill bit and put your bit in your drill
Use 80 grit sand papre.
Sand in till your ring is smith.
Rand your ring and the edges of your ring by sanding with 80 grit sand paper.
Sand with 400 grit sand paper.
Sand the in side of your ring with 400 grit sand paper.
Sand with 600 grit sand paper on the in and out side of your ring in till extremely smith.
Use the paper towel to Surper glue your ring
Let the glue dry for 5 to 6 minis and repeat this process 10 times oval
glue the in side of your ring and Let it dry for 5 to 6 minis repeat this process 10 times oval
Use 600 grit sand paper to hand sand your ring.
Sand your ring in till it is smith.
- A smll saw
- You will need in total
- 6 or 7 vinears
- A wide cramp
- titebond3 glue
- A drill
- A home made bit
- Surper glue
- Papre towel
- Sand papre.80.400.600.
- A woodin jig
- A cramp