How to make a "tree of life" bracelet

Make a "Tree of Life" Bracelet

31
STEPS
TOOLS

Supplies picture

Supplies picture

Step 1:  Measure your wrist

Step 1: Measure your wrist

Step 2:  Cut the wire with clippers.

Step 2: Cut the wire with clippers.

Step 3: Measure 2 arms length of string.

Step 3: Measure 2 arms length of string.

Step 4: Double knot one end of wire.

Step 4: Double knot one end of wire.

Twist the string towards you

Twist the string towards you

Make sure to twist it tight!

Make sure to twist it tight!

Keep on going until you reach the other side.

Keep on going until you reach the other side.

Double knot the end, make sure the knot is tight!

Double knot the end, make sure the knot is tight!

Pull the string until secure enough.

Pull the string until secure enough.

Your almost done! Just cross cross and tie off each end of the string.

Your almost done! Just cross cross and tie off each end of the string.

Pull until desired length.

Pull until desired length.

Double knot the ends.

Double knot the ends.

If you have extra wire, cut it off with wire clippers.

If you have extra wire, cut it off with wire clippers.

Add a decorative charm (or two!)

Add a decorative charm (or two!)

And you know have a wonderful Tree of Life bracelet!

And you know have a wonderful Tree of Life bracelet!

Remember, don't make this bracelet look perfect, flaws are what make it special.

Remember, don't make this bracelet look perfect, flaws are what make it special.

  • 2.0 Bamboo Cord (arms length)
  • 5.0 Minnie Jump Rings
  • 16 Gauge Copper Wire
  • 1.0 "Tree Of Life" Charm
  • 1.0 Wire Clippers
  • Tape