Snapguide
STEPS
TOOLS
Supplies

Supplies

Use the 5" pattern piece as a guide

Use the 5" pattern piece as a guide

Cut cardboard to 5 inches wide. The length of the template varies depending on ribbon size. I like to make my templates longer in order to have enough room when working with the wider ribbon

Cut cardboard to 5 inches wide. The length of the template varies depending on ribbon size. I like to make my templates longer in order to have enough room when working with the wider ribbon

For the 5" template measure 2" in from each outside edge and mark. Take the ruler and draw a line 6"-6.5" from the bottom up. Draw a line connecting the 1st 2 lines. You should have 1" in between

For the 5" template measure 2" in from each outside edge and mark. Take the ruler and draw a line 6"-6.5" from the bottom up. Draw a line connecting the 1st 2 lines. You should have 1" in between

Grab your X-Acto knife

Grab your X-Acto knife

This is what your template should look like Sorry mine is a little ragged, forgot to change my X-Acto blade

This is what your template should look like Sorry mine is a little ragged, forgot to change my X-Acto blade

I always like to measure again after I make the cut to be sure that the two legs are even. This helps to keep all of your bow loops even.

I always like to measure again after I make the cut to be sure that the two legs are even. This helps to keep all of your bow loops even.

At the top of your template mark your center Template 5" and opening 1" mark should be centered above opening  if measuring the width of template 5"/2=2.5" or "1.0/2=0.5" opening.

At the top of your template mark your center Template 5" and opening 1" mark should be centered above opening if measuring the width of template 5"/2=2.5" or "1.0/2=0.5" opening.

Finally mark your template:  I write the following on each template center guide used to keep bow loops even, size of template, and length of ribbon needed to make the bow. (Find in next tutorial)

Finally mark your template: I write the following on each template center guide used to keep bow loops even, size of template, and length of ribbon needed to make the bow. (Find in next tutorial)

Repeat these steps to make a 4 inch and 3 inch template.

Repeat these steps to make a 4 inch and 3 inch template.

Working on the how to use your new bow template should be uploaded shortly

Working on the how to use your new bow template should be uploaded shortly

  • Cardboard, chip board, poster board
  • Self - healing cutting mat
  • Quilters ruler
  • Any other straight edge ruler
  • Rotary cutter
  • X-Acto knife
  • Pencil
  • Scissors if previous cutting tools are unavailable
  • Pattern with measurements