How to make a reversable tree skirt

Gather your supplies

Make a template by folding the paper in half

Draw a line 1.5 inches down from folded corner

Draw a second line 18 inches down from same corner

Cut along both lines

Open paper out and place straight edge on fold of main fabric. Repeat on batting

Cut an opening from outer circle to neck in main piece and batting

Fold paper template in half and half again to give a segment template . Cut 2 of each of the 4 fabrics adding .25 inch seam allowance

Sew segments together in an alternating pattern and press seams open

Layer and pin batting and main fabric pieces. Pin and sew lace around outer edge as close the edge as you can

Turn lace back on itself to finish at the ends

Lay the segmented piece on top of lace trimmed back and pin in place . Sew all around from batting side leaving a 6 inch gap in one of the opening sides. Make sure the lace is tucked in

Trim excess and make notches in neck before turning right side out through the 6 inch gap

Sew gap closed and press . Sew down each segment seam

Cut ribbon into 6 equal lengths and sew in place , 3 matching pairs spaced as shown

All ready for the tree or use the reverse side

Reverse side