Snapguide
STEPS
TOOLS
Get out some jarrah or pine or any sort of wood and make a template with the design you want

Get out some jarrah or pine or any sort of wood and make a template with the design you want

Lay out the wood on the template to see if it works

Glue the wood (wiping off any wood that goes on the board) then clamp for 4 hours

Glue the wood (wiping off any wood that goes on the board) then clamp for 4 hours

After you cut the board make sure you sand over the board

You have to put oil on three times but wait at least a couple of bourse before you start putting on new oils

  • 2.0m Wooden planks
  • 1.0 PVG Glue
  • 1.0 Saw
  • 1.0 Sander
  • 2.0 Clamps
  • 3.0 Sandpaper
  • 1.0 Sandpaper (80)
  • 1.0 Sandpaper (180)
  • 1.0 Sandpaper (240)
  • 1.0 Sandpaper (320)
  • 1.0 Cooking oil