Brit + Co Guides Logo

How to make a personalized 🔊speaker🔊 box

Make a Personalized 🔊speaker🔊 Box

13
STEPS
TOOLS

Note: mini speakers I used were in a small cube box. They already have headphone jack attached and can be taken apart to be mounted on to another box. Not sure if they can be purchased as is.

Supplies, here u can see what I mean by headphone jack being attached.

Supplies, here u can see what I mean by headphone jack being attached.

Box I've chosen to use

Box I've chosen to use

This is how they can be taken apart.

This is how they can be taken apart.

Top pic shows where I'll be placing speakers.  Center and bottom pic I marked section to be cut.

Top pic shows where I'll be placing speakers. Center and bottom pic I marked section to be cut.

Since its personalized I added my daughters name first initial "K".  This will also be cut out.

Since its personalized I added my daughters name first initial "K". This will also be cut out.

Used xacto knife to make cut for speaker to be fitted.

Used xacto knife to make cut for speaker to be fitted.

Perfect fit

Perfect fit

Since speakers are attached to each other I will have to put one through hole and bring out on other side.

Since speakers are attached to each other I will have to put one through hole and bring out on other side.

Made small cuts to fit speaker in.

Made small cuts to fit speaker in.

Here I already cut out the "K"

Here I already cut out the "K"

Will use cut out for detail inside the box to give it a dimensional look.

Will use cut out for detail inside the box to give it a dimensional look.

Painting process.  I used black inside the box. When using spray paint pls make sure to wear proper protective gear.

Painting process. I used black inside the box. When using spray paint pls make sure to wear proper protective gear.

This is what happens when no protection is used.  You become part of the project.

This is what happens when no protection is used. You become part of the project.

Used purple on the cut out letter "K" and on outer side of box.

Used purple on the cut out letter "K" and on outer side of box.

Outer side of box

Outer side of box

Here u can see how by placing cut out inside the box it gives it that dimensional look

Here u can see how by placing cut out inside the box it gives it that dimensional look

Used tape to conceal the wire

Used tape to conceal the wire

Made a side cut for headphone jack

Made a side cut for headphone jack

Project complete

Project complete

On my daughter's wall. I added a key ring to the back so it can be hanged on wall

The creator of this guide has not included tools