STEPS
TOOLS
gather your tools
measure piece of metal to 8cm x 8cm
cut off square
connect diagonal corners to eachother
find the centre where the two lines meet then make an indent
draw a circle around it
cut it out
file it to make it smooth
hammer it into a slight bowl shape
drill press a hole into the middle
get piece of flat bar and file ends
bend piece so there is a curve at one end
it should look like this
and like this
draw line from corner of un blended edge to where it meets diagonally with the side.do this for both corners
then measure 1.5 cm in
drill press hole at centre where the lines meet
then bend that so it's into a light bend so it can stand
measure up all the holes you have made and ready a nail there
pop rivit all your components of the holder and then your finished :)
- scriber
- metle ruler
- centerpunch
- ball pein hammer
- hacksaw
- vice
- drill bit
- divider
- tin snip
- file
- drill press
- pot rivit gun
- tin snips
- gullotiens
The Conversation (0)
Sign Up