How to make a hockey gear stand

Make a Hockey Gear Stand

49534
STEPS
TOOLS

The finished product

The finished product

Make sure to cut the 7 - 7" pcs. and the 2 - 18" pcs. off of one of the 8' pipes and the rest off the other 8' Pc.

The measurements for the top

The measurements for the top

Measurements for bottom

Measurements for bottom

Add any type of clip to hold shin pads.

Add any type of clip to hold shin pads.

Add a hook on the middle pipe to hold the pants.

Add a hook on the middle pipe to hold the pants.

You can choose to screw together joints for stability or just hand tighten for easy disassembly in the offseason.

You can choose to screw together joints for stability or just hand tighten for easy disassembly in the offseason.

(Optional) Customize with air cooling. Replace the PVC Tee with the 4 hole joint.

(Optional) Customize with air cooling. Replace the PVC Tee with the 4 hole joint.

Drill strategic holes in pipe to allow airflow into gear for faster drying.

Drill strategic holes in pipe to allow airflow into gear for faster drying.

Holes on caps

Holes on caps

Good luck in your season and go Blackhawks.

Good luck in your season and go Blackhawks.

  • 9.0 1-1/2" Pvc Caps
  • 2.0 1-1/2" PVC Elbows
  • 1.0 1-1/2" PVC cross (4 hole joint)
  • 5.0 1-1/2" PVC Tees
  • 2.0 Spring clips
  • 1.0 Hook
  • 2.0 8' 1-1/2" PVC pipe
The Conversation (0)