Snapguide
STEPS
TOOLS
Step 1: Cut off the bendy end of the straw.

Step 1: Cut off the bendy end of the straw.

Step 2: Roll out some duct tape and place the straw on the sticky side.

Step 2: Roll out some duct tape and place the straw on the sticky side.

Step 3: Cut the tape at the end of the straw.

Step 3: Cut the tape at the end of the straw.

Step 4:  Roll the straw up in the tape tightly. Make sure there are no bumps in it.

Step 4: Roll the straw up in the tape tightly. Make sure there are no bumps in it.

Step 5: measure out some more duct tape. Each piece has to be 2inches each, and cut them.

Step 5: measure out some more duct tape. Each piece has to be 2inches each, and cut them.

Step 6: Fold one corner over so that is makes half a triangle, sticky side touching sticky side.

Step 6: Fold one corner over so that is makes half a triangle, sticky side touching sticky side.

Step 7: Fold the other end just like the first, leaving some of the sticky side at the bottom.

Step 7: Fold the other end just like the first, leaving some of the sticky side at the bottom.

Step 8: Roll that piece up tightly.

Step 8: Roll that piece up tightly.

Step 9: Place that piece into one end of the straw.

Step 9: Place that piece into one end of the straw.

Step 10: Repeat steps 6-7 and wrap the petals around the start.

Step 10: Repeat steps 6-7 and wrap the petals around the start.

Step 11: Make it as big as you want.

Step 11: Make it as big as you want.

Step 12: to make the leaves, do the same steps as you did for the petals and place them at the bottom.

Step 12: to make the leaves, do the same steps as you did for the petals and place them at the bottom.

  • Any color of Duct Tape
  • Straws or pens
  • Ruler
  • Scissors