How to make a duct tape bow

Make a Duct Tape Bow

21
STEPS
TOOLS

Grab all of your supplies

Grab all of your supplies

Grab the duct tape and exacto knife (or scissors), and cut your duct tape. The "body" of the bow should be about 7 1/2 inches, and the other part should be a couple of inches

Grab the duct tape and exacto knife (or scissors), and cut your duct tape. The "body" of the bow should be about 7 1/2 inches, and the other part should be a couple of inches

Now fold the "body" piece almost in half, but leaving a little bit of the sticky side left

Now fold the "body" piece almost in half, but leaving a little bit of the sticky side left

Now fold over that little sticky part, so there isn't anymore sticky sides showing.And then cut a thin strip of tape from the other piece.

Now fold over that little sticky part, so there isn't anymore sticky sides showing.And then cut a thin strip of tape from the other piece.

It should look like this

It should look like this

Get your bobby pin and slide it in between the backside of the strip of tape you just put on. Like this:

Get your bobby pin and slide it in between the backside of the strip of tape you just put on. Like this:

The finished product.....!! I hope you liked it! Please like and comment ;D

The finished product.....!! I hope you liked it! Please like and comment ;D

  • 2.0 Rolls of Duct Tape
  • 1.0 Exacto Knife or Pair of Scissors
  • 1.0 Bobby pin
  • 1.0 Cutting surface or Unused Clipboard