How to make a dragon sculpture volcano day:2

With all your squares you need to position them so then there in a cube with no top or bottom on it

After you make the cube you need to scratch the sides. As shown above

Now rub water on both of the scratches

Now add the two scratches together and push down until water starts to come out of the two squares

Scrape the clay over the two squares as shown

Now add a little piece of clay to stick the two squares together

Repeat the steps

Now with your two half cubes you need to scratch were you are going to stick them together

Now put water on all the places you've scratched

Stick them together

Scrape the clay over the cracks

Put another piece of clay between the squares to secure the cube

Roll another piece of clay the width of your finger

Place the sort of cube on top of the clay

Now make a outline of the bottom of the cube

Cut the outline out

Scratch the top of the sort of cube and rub water on the scratch

Now place the square on top of the cube and scrape clay over the crack

Add some clay pieces in the corner

Could I get a crazy 10 likes thx piece out. 👍✌️