How to make a double strand paracord diamond knot

I found some scrap cord and decided to use it, you can cut a new length or find scrap cord.

Find the middle of the cord and put the key ring in the middle of the cord.

Make a loop with the left side of the cord, like so in the picture.

Make a loop with the right side of the cord, like so in the picture.

Cross the left cord u see the right one, like so in the picture above.

Pick it up, if you weren't like me in the picture and hold it like I am or however is comfortable.

Bring the 2 loops together like so in the picture above.

Then weave the cord that's closest to you through the 2 loops like so in the picture above.

Should look like this after woven.

Bring the cord on you right over, like so in the picture above.

And through the middle hole of the weave. Like so in the picture above.

Then tighten it just a little bit so everything won't be so loose.

Then bring the cord on the left under and around. Like so in the picture above.

Then bring it through the center hole like what you did with the previous cord. Like so in the picture above.

Pull both the bottom and the top double strands apart gently to help tighten and to help move the string into place. Like so in the picture above.

Should look similar like in the picture above.

You can tug on the knot gently to help tighten as well.

Should look a little similar in the picture above.

You can use your finger to help push the loose cords into place and pull some more to tighten it.

Use your fingers to help round it, like so in the picture above.

Once finished, this should be your finished result.

Thanks for viewing! I hope it wasn't to confusing. Subscribe to keep updated on what I post in the future!