Snapguide

How to make a candle holder out of a pop can

So now you have all of these soda cans without tops. Recently saw another guide that gave me an idea

43
STEPS
TOOLS
Check out her guide (one of my liked guides) This is why I love snap guide, everyone sharing ideas, kinda restores my faith in humanity

Check out her guide (one of my liked guides) This is why I love snap guide, everyone sharing ideas, kinda restores my faith in humanity

I used spray adhesive, that worked well, but for the next one I'm going to use gloves as I have glue all over my fingers. I would also use newspaper to get all of the overspray

I used spray adhesive, that worked well, but for the next one I'm going to use gloves as I have glue all over my fingers. I would also use newspaper to get all of the overspray

I sprayed a liberal amount on the can till it was tacky

I sprayed a liberal amount on the can till it was tacky

I used my glue gun to hold down the initial twine.

I used my glue gun to hold down the initial twine.

And just keep wrapping and pressing it down into the glue

And just keep wrapping and pressing it down into the glue

Glue gun the end and you're done. I'm going to use sand or small stones to weigh it down, then use a tea candle inside. It took about 10 min to make, start to finish

  • Spray adhesive
  • Soda can
  • Twine
  • Glue gun