Snapguide
STEPS
TOOLS

Cut an opening in the front of the first can

Cut an opening in the front of the first can

With the second can cut a long strip off the face of the can

With the second can cut a long strip off the face of the can

(1.)First can with open part  (2.) Second can strip  (3.) Little can opener piece from the first can

(1.)First can with open part (2.) Second can strip (3.) Little can opener piece from the first can

Super glue the can to the piece of wood

Super glue the can to the piece of wood

Super glue the strip from the second can to the bottom of the first can. Leave enough room for the bird to sit on it

Super glue the strip from the second can to the bottom of the first can. Leave enough room for the bird to sit on it

Glue the little can opener piece to the top of the wood board

Glue the little can opener piece to the top of the wood board

Cut two pieces of string into about a foot each

Cut two pieces of string into about a foot each

Cut two holes into the end of the can strip and stick string through the hole and tie knots at the bottom

Cut two holes into the end of the can strip and stick string through the hole and tie knots at the bottom

Take both pieces of string and wrap them around the back of the can then wrap the string around the back of the wood

Take both pieces of string and wrap them around the back of the can then wrap the string around the back of the wood

Take both pieces of string and tie a knot in the back

Take both pieces of string and tie a knot in the back

Cut two more pieces of string about a foot each

Cut two more pieces of string about a foot each

Run the string through the little can opener piece at the top of the piece of wood

Run the string through the little can opener piece at the top of the piece of wood

Hang it anywhere

Hang it anywhere

  • 2.0 Beer Can
  • 4.0ft String
  • Knife/Scissors
  • Super Glue
  • 1.0 Thin Piece of Wood