Use white cardstock of 4.5" x 5.5". Using the MFT die to cut a hole where u want the shaker to be.

You get an inner square measuring 3" x 3"

Use a regular square die that is slightly smaller at 2.5" to cut the border

This is what you get.

Cut another white cardstock measuring 3" x 3" to stamp the image

Cut an acetate measuring 3" x 3"

Finish colouring the stamped image. I used glossy accent on the heart to give it a shine!

Cut a foam sheet measuring 4.75" x 5.75" and cut another square measuring 3" x 3". Make sure it aligns with the 1st square on the white card

Add double sided adhesive to back of white card and adhere to foam sheet

Adhere

Cut another white cardstock measuring 9.5"(folded in half) x 5.75". This is your card base. Cut the 3" x 3" square again. Align with previous squares cut

So you have the white card adhered to foam sheet that is adhered to white card base. Stamp caption.

Use double sided tape behind foam sheet

Add your "shakees" for your shaker card

Close the card and align the shaker card to the inside of the card base and adhere

Here's the card when opened. Tip: stamp your caption, in this case, You're My Type, on top of the image rather than below so that the shakees doesn't cover the words

And here's the finished card! Happy Valentine's Day everyone!