How to create a rainbow loom triple single

1.Get one color of your looms and place it on the left side of the board

Keep adding the looms onto the board

When you are done,it should look like this

2.Next you get a different color and do the same except in a different row

I do exactly the same with what I did before with the blue looms

3.And now I do the same with the last two getting a different color and placing it on the right row of the board

When you have finished,your board should look like this

4.Now we will be adding the triangle looms

Flip the board over and use only three pegs to make one triangle

Keep adding the triangles but leave three pegs at the top as shown

5.Now we will be looping the looms to make our bracelet

To loop the yellow loom you must put the hook under the orange to make it work

Then once you have the yellow loom in your hook carry it over and onto the peg in front as shown

Keep looping the yellow as shown until you reach the top

Now you do the right as the middle row will be different from the other two

As you can see in the middle row you don't have to put the hook under the orange you just loop it

When you are done it should look like this

6.After you have finished go to the top of the board where the three looms are,put the left loom onto the middle and do the same with the right

Pick up the yellow and put it in the middle

And do the same with the right

7.You then put the hook inside the top/middle row and put a loom around it,then add a clip

Put the hook under the looms

Then get the loom and place it onto the hook

Then replace the hook with the clip

And finally carefully peel the bracelet off

This is how it should look like while you are peeling it off

But your triple single is not finished yet ,now add the end loom to the clip

And there is your finished triple single