STEPS
TOOLS
Supplies
Cut 4, 9 1/4 in inches of ribbon, heat seal
Put a little bit of glue on the end
Take the other end and put it over the glue
Put a little bit of glue on the inside
And the find the center and push down, do it to the other pieces of ribbon
Put it down and put glue in the middle
Lay another piece if ribbon on top
And repeat 7 and 8 over again until you use up all of the ribbon
Cut 4, 6 1/2 inches of a different ribbon and heat seal
Repeat step 3 to 8 over again to make the other flower
Put the two bows together with glue
Add a jewel with glue
Cut a 3/8 inch piece of ribbon and heat seal. Then put some glue on the end and slip it on the alligator clip
Add glue on the top and pull the ribbon over
Then put some glue on the back and put the ribbon over it
Glue it on the back, ribbon side
Now you're done!
- 2.0 5/8 ribbon
- Hot glue
- Lighter or clear nail polish
- Alligator clip
- Jewel
- Tape measure
- Scissors
The Conversation (0)
Sign Up