This is the stove, and this guide will help you make it. :)

2 Cans, you can use Pepsi, beer or other brands. While I feel this design is very safe use this at your own risk.

Mark some lines on the cans One just under an inch The other just over an inch & quarter

Top tip to get straight lines - turn the can on a flat surface.

First on the can with the line that is higher do a rough cut.

Do a final cut. Here I'm cutting in an anticlockwise direction even though its hard to see the line. Cutting clockwise would not give me a straight line.

While one is still uncut force the can inside the other.

Twist it in. Then twist it out. Do this a couple of times.

Now on the uncut can make 8 holes with a pin. This is actually fairly easy to do.

Make one in the middle.

Cut that can out as well now

Slide one in the other like so. Be a little patient and don't force it.

Push it all the way down.

Make another 3 holes around the centre hole - this can be done when making the other holes.

Put a penny on top, make some wind shields if you wish.