This is the stove, and this guide will help you make it. :)
2 Cans, you can use Pepsi, beer or other brands. While I feel this design is very safe use this at your own risk.
Mark some lines on the cans One just under an inch The other just over an inch & quarter
Top tip to get straight lines - turn the can on a flat surface.
First on the can with the line that is higher do a rough cut.
Do a final cut. Here I'm cutting in an anticlockwise direction even though its hard to see the line. Cutting clockwise would not give me a straight line.
While one is still uncut force the can inside the other.
Twist it in. Then twist it out. Do this a couple of times.
Now on the uncut can make 8 holes with a pin. This is actually fairly easy to do.
Make one in the middle.
Cut that can out as well now
Slide one in the other like so. Be a little patient and don't force it.
Push it all the way down.
Make another 3 holes around the centre hole - this can be done when making the other holes.
Put a penny on top, make some wind shields if you wish.
- 2 Beverage Cans
- Pinboard Pin
- Methylated spirit
London, United Kingdom.