How to change the plug on a juicer

PLEASE REMOVE PLUNGER AND DETACH AUGER ASSEMBLY

THIS IS WHAT THE UNIT SHOULD LOOK LIKE AFTER REMOVING AUGER

PLACE UNIT ON TOWEL OR SOFT RAG TO AVOID SCRATCHING IT. PLEASE TURN IT ON IT'S SIDE

USING A PHILIPS SCREWDRIVER, PLEASE REMOVE THE 4 SCREWS LOCATED ON THE BASE OF THE UNIT. THEY ARE LOCATED NEXT TO EACH OF THE RUBBER BASE FEET. PLEASE DO NOT REMOVE BASE FEET SCREWS.

ROTATE THE UNIT, AND REMOVE THE 4 SCREWS LOCATED AROUND THE AUGER DRIVE.

BEFORE REMOVING THE TOP SCREW, PLEASE USE A MARKER AND PLACEA LINE UNDER THE SCREW. THIS WILL HELP TO MAKE SURE THE LOCKING RING LINES UP WITH THE AUGER AFTER REPAIR.

THIS IS WHAT YOU SHOULD SEE ONCE THE SCREWS ARE REMOVED.

REMOVE THE TOP COVER BY SIMPLY PULLING UP ON THE HANDLE

PLEASE NOTE THE FUSE AND FUSE HOLDER. PLEASE BE CAREFUL NOT TO DISLODGE THE FUSE. PLEASE DISCONNECT THE WIRES FROM THE PLUG, AND REPLACE WITH NEW.

AFTER CHANGING PLUG, PLEASE REPLACE THE SCREWS, AND ASSEMBLE THE UNIT.