Snapguide
STEPS
TOOLS
First get your supply. I had my 2x4 precut so it would be faster.

First get your supply. I had my 2x4 precut so it would be faster.

Then put pocket holes on both sides of the 4x4.

Then put pocket holes on both sides of the 4x4.

Once you've connected all the 4x4, use the 2x4 to post as a brace. And cut your Angles and then use your kreg jig and then put screw them on.

Once you've connected all the 4x4, use the 2x4 to post as a brace. And cut your Angles and then use your kreg jig and then put screw them on.

Then the 2x4 that was cut at 1 feet each, connect them to each side of the 4x4 as the base so your stand will stand on its own.

Then the 2x4 that was cut at 1 feet each, connect them to each side of the 4x4 as the base so your stand will stand on its own.

Here's a picture of how it looks with the topsy turvy's now it's time to fill them up. Enjoy!

  • 3.0 4x4
  • 8.0 2x4 @ 1 foot each
  • 4.0 2x4 @ 2 ft each
  • 1.0 2 1/2 inch box pocket screws
  • 1.0 Kreg jig or pocket hole jig.
  • 1.0 Drill