Snapguide

How to attach a small torch (flashlight) to your belt

Attach a Small Torch (Flashlight) to Your Belt

16
STEPS
TOOLS
Cut a length of approximately 15cm of webbing strap. Heat seal the ends using a lighter or match to stop it fraying.

Cut a length of approximately 15cm of webbing strap. Heat seal the ends using a lighter or match to stop it fraying.

Obtain a small torch, LED type is best. It's better to use one that has a narrower middle with wider ends, this will prevent it from sliding out.

Obtain a small torch, LED type is best. It's better to use one that has a narrower middle with wider ends, this will prevent it from sliding out.

Attach a male press stud close to one end.

Attach a male press stud close to one end.

Place the strap around your belt and torch to find the right position for the female press stud. This should be attached on the opposite side of the strap.

Place the strap around your belt and torch to find the right position for the female press stud. This should be attached on the opposite side of the strap.

Strap shown with both press studs attached.

Strap shown with both press studs attached.

The press studs should connect the strap together in a loop.

The press studs should connect the strap together in a loop.

Fit the completed strap around your belt and torch. Now you'll always have a torch available when you need one.

  • 1.0 Small LED Torch (Flashlight)
  • 15.0cm Webbing Strap
  • 1.0 Male Press Stud
  • 1.0 Female Press Stud
  • 1.0 Press Stud Application Tool
  • 1.0 Belt