Snapguide

How to apply jules petg settings to simplify 3d

Apply Jules PETG Settings to Simplify 3D

2
STEPS
TOOLS

Jules recommends using .25 for layer height but I have found 2.0 works just fine.

Jules recommends using .25 for layer height but I have found 2.0 works just fine.

Continued on next photo

Continued on next photo

Make sure you use calipers to measure the actual width of your filament and enter it here.

Make sure you use calipers to measure the actual width of your filament and enter it here.

To read the settings, go to this site. https://www.xyzfabs.com/forums/topic/63/print-settings-for-petg-esun-solid-black-filament/

To read the settings, go to this site. https://www.xyzfabs.com/forums/topic/63/print-settings-for-petg-esun-solid-black-filament/

  • 1.0 3D Printer
  • 1.0 Copy of Simplify 3D
  • 1.0 roll of PETG